[. . . ] € NEVER use the hood as a support, unless expressly instructed to do so. € The room must be adequately ventilated if the hood is used at the same time with other equipment burning gas or other fuels. € Extracted air must not be conveyed into a duct used for exhausting combustion fumes from gas or other fuel-fired equipment. [. . . ] Do not connect the hood to flues carrying combustion fumes from other equipment (boilers, TBOXs, stoves, etc. Observe the instructions of the competent authorities in relation to the air exhaust. The air being exhausted may not be exhausted into a wall cavity unless the cavity in question is specifically intended for this purpose. Equip the room with air intakes to prevent the hood creating suction pressure in the interior (this must not exceed 0. The manufacturer is not liable for any consequences of failure to observe these instructions. Of exhaust tube (cm) 15/12 15/12 Bulb draw (W) Total draw (W) 2 x 20 2 x 20 240 290 Power Halogen 25 W Halogen 20 W 2 x 25 W 2 x 20 W Voltage 230 V 12 V Cap G9 G4 Dimensions L40xØ14 L30xØ10 LED * Risk Group 1 according to Standard EN 62471 Filter or ducted?If you wish to use it as a filter unit, you must install the proper ACCESSORY KIT. Note: If supplied with the hood, the accessory active charcoal filter unit may already be installed. Instructions for transforming the hood from the ducted to the filter version are given in this manual (see “Filter version”). The hoods are conforming to the following EC Directives: • “Low voltage” Directive 2006/95/EC (12-12-2006) • “EMC” Directive 2004/108/EC (15-12-2004) * Only available in certain models 15 GB TBOX controls Models with mechanical keypad (Only available in certain models) The T2 icon flashes to indicate that the grease filter is saturated, while T3 flashes to indicate that the odour filter is saturated, and if both are flashing then both filters are saturated. You must then clean/replace the grease filter (A) or odour filter (B) or both, accordingly (see “Maintenance and care”). To reset the filter counter: Hold down T4 for three seconds while the hood is on. The warning led flashes three times, then returns to its normal mode If both filter warnings are active at the same time, you must reset each separately. The first sequence resets the grease filter, while the second sequence resets the odour filter. Hood configuration: To set the operating mode of the hood, hold down T5 for 6 seconds while the product is off. Icons T2 or T3 will light up to show the type of installation: T2 ventilation, T3 filtering. T1 T2 T3 T4 T5 T1 Motor reset Pressing the button while the hood is in operation turns it OFF. 8 ADI X B Models with soft button keypad (Only available in certain models) B T1 T2 T3 T4 T5 T6 T1 T2 T3 T4 T5 T6 T1 Motor reset Pressing the button while the hood is in operation turns it OFF. [. . . ] After a long beep, the type of installation displays: Ducted (square at bottom left flashing). To quit configuration mode, press T1 once; this switches the unit off and saves the last displayed setting. Before cleaning or servicing the unit, disconnect it from the mains by pulling the power plug or disconnecting the main circuit breaker. [. . . ]